![]() ![]() Use this guide to set it up.Īs part of the Raspberry Pi Imager setup, you specified a username and password to use. Windows: PowerShell SSH (Needs to be enabled in Windows 10.macOS: Terminal (built-in) or iTerm2 (download).Linux: Terminal, X-Term or the console screen if you have no GUI installed.Some examples that are available include: Which application you use depends on your computers Operating System. You will need to use a terminal application to use SSH. SSH is used to remotely connect to Ubuntu (or Linux in general) to allow you to run terminal commands. You can then install the MicroSD card and connect up the Ethernet cable and power adapter to the Pi. I placed a bit of electric tape over the RTC module as it was going into an aluminium case which it shouldn't come into to contact with but I figured it's better safe than sorry. For my RTC module, I needed to install it onto pins 1, 3, 5, 7 and 9 but yours might be different. You can then proceed to install the module onto the GPIO pins on the Pi. You should be able to find this by looking at the text on the module or you can find it from the vendors description from where you bought it, which might be easier. To begin with, you will need to check which chipset is on your RTC module. This should have 64-bit listed under the title. ![]() When you get to step 2, instead of selecting Raspberry Pi OS, go to Other general purpose OS > Ubuntu > Ubuntu Server 20.04.4 LTS (RPI 3/4/400).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |